Sharp DV-NC65S - Page 39

39
DV-NC65H/S
DV-NC70H
Figure 8-38.
Loading arm (T)
Sifter
Insert point
Loading arm (T)
Loading arm (S)
Phase matching
*Not run on the
sifter.
Sifter
Tension arm
a
c
b
8-24. INSTALLING THE SIFTER
Figure 8-37.
Drum
Capstan D.D.
motor
(Bottom side of mechanism chassis)
* Remove the SUP/TU main brake before installation.
1. Make sure that the loading arm T and S are at the Phase-
Matching point as shown below .
2. Fix the sifter position setting part to the roading arm T
position setting part as shown in figure .
3. Make sure tension arm not run on the sifter as shown in
figure .
a
b
c