Sharp EL-1607P

5
ROUNDING SELECTOR:
“ ”: An answer is rounded up.
“5/4”: An answer is rounded off.
“ ”: An answer is rounded down.
Note: The decimal point floats during successive
calculation by the use of or .
If the decimal selector is set to “F” then the answer
is always rounded down ( ).
GRAND TOTAL MODE SELECTOR:
“GT”: Grand Total
“• ”: Neutral
STORE KEY:
This key is used to store the conversion rate
or the tax/discount rate.
Conversion rate:
• Enter the conversion rate, then press
.
• A maximum of 6 digits can be stored
(decimal point is not counted as a digit).
Tax/discount rate:
• Enter the adding tax rate, then press
.
• To store a discount rate, press before
pressing .
• A maximum of 4 digits can be stored
(decimal point is not counted as a digit).
Note: • For the conversion rate and the tax/
discount rate, a single value can be stored
for each. If you enter a new rate, the
previous rate will be cleared.
PAPER FEED KEY
LAST DIGIT CORRECTION KEY
GRAND TOTAL KEY
CLEAR ENTRY KEY
TOTAL KEY
MULTIPLICATION KEY
DIVISION KEY
MINUS EQUAL KEY
PLUS EQUAL KEY
CHANGE SIGN KEY
MARKUP KEY
MEMORY TOTAL CLEAR KEY
EL-1607P(ACO)-Eng 03.10.9, 8:58 AM5