Sharp EL-6790

To transfer all the data by mode, press the mode key to
display the entry prompt. To transfer the data by entry,
recall the desired listing.
. Press on
both the Organizers.
The following menus are
displayed.
. Press @ on the receiving
Organizer to select RECV
(RECEIVE).
«UNIT TO UNIT»
ISEND 4:BACKUP
cs 27RECV S:RESTORE
‚ SVERIFV
KUNIT TO UNIT»
CAPS RECEIVING
MODE
è
. Press CD on the transferring Organizer to select SEND.
. Data transfer is started.
To interrupt data transfer, press (ON).
Messages are displayed on the respective Organizers while
data is being transferred.
Transferring Organizer
«UNIT TO UNI T»
cps -SENDING-
^
Receiving Organizer
«UNIT TO UNIT»
caps, -RECEIVING-
^
When these messages are no longer displayed, the data
transfer is completed.
To verify the listing after it has been transferred, select (D
(VERIFY) on the receiving Organizer in step 3.
The following message is «UNIT TO UNI T»
displayed.
cars -VERIFYING-
^
If any discrepancies are found, "VERIFY ERROR !” is displayed.
Transferring data between Telephone/E-mail mode and URL
mode
Transferring data is possible between Telephone/E-mail mode
and URL mode. When TEL (or E-mail) data is transferred to
URL data, the E-mail (or postal) address is displayed followed
by the postal (or E-mail) address on the receiving Organizer.
The E-mail (or postal) address returned to the transferring
Organizer is relocated to its original field.