Sharp EL-6790

The Backlight is nullified during data transfer. (When the
Backlight is turned on, it is automatically turned off at the
beginning of data transfer.)
When the Organizers are not in the same mode before
transferring data by entry or mode, "DATA ERROR !” is
displayed and no data transfer is allowed.
However, directories in the TEL (or E-MAIL) and URL mode
are excluded from this rule. For example, data in the TEL/
MAIL1 directory can be transferred to the URL directory.
When the communication cable is disconnected during data
transfer, “1/0 DEVICE ERROR !” is displayed. Press
to clear the error, check that the Organizers are connected
correctly, and then start the steps again.
The indication "Replace the OPERATING batteries !” shown
when are pressed means that the
operating batteries are almost exhausted. Replace them
with new ones then try again to transfer data.
When "MEMORY FULL" is displayed and data transfer is
aborted, perform the following step:
~ delete unnecessary data on the receiving Organizer, then
start the steps from the beginning.
The indication "WORKING..." shown on the side of the
receiving Organizer at the beginning or end of the data
transmission means that the memory has begun to be freed
up automatically.
| 2. Transferring Data between Organizers
The single data entry or entire data in a mode (TEL, E-MAIL,
URL, SCHEDULE, MEMO/ANN) can be transferred between
Organizers.
• Turn both of the Organizers off first before connecting them
with the SHARP-specific cable.
The shape of the cable illustrated above may be different
from that of the final shipment.
When an error occurs, “1/0 DEVICE ERROR” is displayed on
the receiving or transferring Organizer, or on both ones.
. Press the desired mode key, or recall a listing to be
transferred on the transferring Organizer.
33