4
Programming for optional feature selection
For the programming procedure, refer to the instruction manual.
• Some items on “P: 9” are newly added functions for the introduction of EURO, which do not
described on your instruction manual.
P: 9
Exchange 1 calculation method
“Division” or “Multiplication” can be selected for the conversion method from domestic currency to exchange 1
currency, and the calculation is performed as follows:
In case that “Division” is selected for the period 1,
Domestic currency amount (national currency amount) Exchange 1 rate (EURO conversion rate) = Exchange
1 amount (EURO amount)
In case that “Multiplication” is selected for the period 2,
Domestic currency amount (EURO amount) Exchange 1 rate (EURO conversion rate) = Exchange 1 amount
(national currency amount)
Printing of the exchange 1 total amount and change amount on the receipt/journal
Total and change amounts in exchange 1 currency are printed respectively below each of the total and
exchange amounts in domestic currency.
On the period 1, EURO amount converted from national currency is printed below the national currency, and on
the the period 2, national currency converted from EURO amount is printed.
Validation printing of the exchange 1 total amount <only for ER-A440>
Exchange 1 amount converted from total sales amount can be printed on the validation print for total amount
when cash, cheque or credit amount tender is performed.
Cash/credit operation for exchange 1
You can set whether you receive foreign currency (exchange 1) amount by cheque or credit or not.
P: 9
Item: Selection: Entry:
A Always enter 0. 0
B Exchange 1 calculation method Multiplication 0
Division 1
C Cheque/credit operation for exchange 1 No 0
Yes 1
D Printing exchange 1 total amount and change No 0
amount on receipt and journal Yes 1
E Printing exchange 1 total amount on validation No 0
printing Yes 1
F and G Always enter 0. 0
H Footer graphic logo printing No 0
Yes 1
• In case that your register is ER-A440, always enter 0 for item H.
• In case that your register is ER-A450, always enter 0 for item E.
• The items B, D and E are automatically set by the operation of job #800.
To Next Page
Loading...
