Sharp GX-CD130 - Removing and Reinstalling Main Parts; Tape Mechanism Components

GX-CD30/30C/130/130C
REMOVING AND REINSTALLING THE MAIN PARTS
How to remove the motor
(See Figs. 6-5 and 6-6.)
1. Remove the belt.
2. Remove the screws (G1) x 4 pcs., to remove the motor fixture.
3. Remove the screws (G2) x 2 pcs., to remove the motor.
Note:
When mounting the motor, pay attention to the motor mounting
angle.
Figure 6-6
Figure 6-5
Figure 6-2
Figure 6-1
Figure 6-4
Figure 6-3
Play Button
TAPE 1
Erase Head
Record/Playback
Head
Pawl
(A1)x2
( B1 ) x2
ø2 x7mm
A
A
Pawl
(C1)x2
Play Button
Playback Head
B
B
TAPE 2
TAPE1
Main Belt
(E1)x1
TAPE2
Main Belt
(F1)x1
Main Belt
(F1)x1
Main Belt
(E1)x1
FF/REW Belt
(E2)x1
Flywheel
Flywheel
Motor
Motor
TAPE 1
TAPE 2
( G1 ) x2
ø2 x4mm
( G1 ) x2
ø2 x4mm
Motor
Bracket
Motor
TAPE2 TAPE1
( G1 ) x2
ø2.6 x2mm
Motor
Bracket
Motor
– 6 –
Pinch Roller
(D1) x 1
Pawl
C
Perform steps 1, 2, 3, 4, 5 and 6 of the disassembly method
to remove the tape mechanism.
TAPE MECHANISM SECTION
How to remove the record/playback and erase
heads (TAPE 1) (See Fig. 6-1.)
1. Carefully bend the record/playback head pawls (A1) x 2
pcs., in the direction of the arrow Â, and remove the record/
playback head upwards.
2. Remove the screws (B1) x 2 pcs., to remove the erase head.
How to remove the playback head (TAPE 2)
(See Fig. 6-2.)
1. Carefully bend the playback head pawls (C1) x 2 pcs., in the
direction of the arrow È, and remove the playback head
upwards.
How to remove the pinch roller (TAPE 1/2)
(See Fig. 6-3.)
1. Carefully bend the pinch roller pawl in the direction of the
arrow Ê, and remove the pinch roller (D1) upwards.
How to remove the belt (TAPE 1) (See Fig. 6-4.)
1. Remove the main belt (E1) x 1 pc., from the motor side.
2. Remove the FF/REW belt (E2) x 1 pc.
How to remove the belt (TAPE 2) (See Fig. 6-4.)
1. Remove the tape 2 main belt (E1) x 1pc., from the motor side.
2. Remove the tape 1 main belt (F1) x 1pc., from the motor side.