Sharp GX-CD555Z - Page 10

How to remove the belt
(See Fig. 8-l .)
1. Remove the tape 2 main belt (E
2. Remove the FF/REW belt(E2).
3. Remove the tape 1 main belt (F
1) from the motor side.
1) from the motor side.
How to remove the flywheel (TAPE2)
(See Fig. 8-2.)
1. Remove the screw with collar (Gl) to remove the pause kick
lever.
2. Remove the washer (G2) upwards.
3. Remove the stop washer (G3) with a small precision
screwdriver to extract the flywheel from the capstan metal.
Note:
If the stop washer is deformed or damaged, replace it with a new
one.
Motor
I
Figure 8-l
Flywheel
use Kick Lever
Fiybvheel
Figure 8-2
How to remove the flywheel (TAPEl)
(See Fig. 8-3.)
1. Remove the washer (Hl) upwards.
2. Remove the stop washer (H2) with a small precision
screwdriver to extract the flywheel from the capstan metal.
3. Remove the washer (H3) upwards.
Note:
If the stop washer is deformed or damaged, replace it with a new
one.
Figure 8-3
How to remove the motor
(See Fig. 8-4.)
1. Remove the 2 screw (Jl) to remove the tape 2 mechanism.
2. Remove the 3 screws (J2) to remove the motor.
(J 11x1
43 2 x4mm
Figure 8-4
-8-