CD
SECTION
As for preparation for adjustment, adjustment method and optical pickup replacement method refer to the Service Manual
“ADJUSTMENT PROCEDURES OF
AUDIO
PRODUCTS
[II]“.
1 .Preparation for Adjustment
Be sure to refer to the Service Manual “ADJUSTMENT PROCEDURES OF
AUDIO
PRODUCTS
[II]“.
Settina
the
Test
Mode
Test
Mode
rEST
MODE
0
rEST MODE 1
Setting
Method
Remarks
Pressing simultaneously the All the segments light for 1.5
“CLEAR” and “CALL” buttons, set seconds and then the Test Mode 0
the function switch to “CD”. indication appears.
In
TEST MODE 0 press once the
Laser lights.
PLAY button. (1st)
c
TEST
MODE 2
In TEST MODE 1 press once the
Focus start
PLAY button. (2nd)
(Servo ON)
TEST
MODE 3 In
TEST
MODE 2 press once the
Disc rotates.
PLAY button. (3rd) (Spin servo ON)
(Use the disc.)
l-EST MODE 4
In TEST MODE 3 press once the Tracking servo ON
PLAY button. (4th)
(Use the disc.)
c
TEST MODE 5
In TEST MODE 4 press once the Track No. and time are indicated.
PLAY button. (5th)
(Use the disc.)
l
Display
,
I
w-l
-IEFil
/
I
I
t
11
:
I38
/
After TEST MODE 5 the PLAY button is inoperative. Even when it is pressed (6th time), key entry is not accepted.
Unless the CD lid switch SW961 is turned on, the test mode is not set.
Button Operation in Test Mode
1.
When the STOP button is pressed, all operations stop. At this time the optical pickup does not slide, and TEST MODE 0 is displayed.
2. While the
UP/CUE(DOWN/REVIEW)
button is pressed, the optical head moves from inside to outside or from the outside to the
inside.
l
Operation is possible both during playing and stopping.
l
While this operation is executed, the TEST MODE indication does not change.
After the optical pickup is
slided
from the outside to the inside and the optical pickup switch is turned on, the slide stops. (At the same
time TEST MODE 0 is set.)
Notes
1
.Any
buttons other than those specified above are invalid.
2.Before
operation be sure to connect all the connectors.
-
12
-
To Next Page
Loading...
