Sharp HT-SB350(W)

E-7
HT-SB350(BK)
2010 August 16 HT-SB350_A6_EN_UK.fm
ENGLISH
HT-SB350(W)
Preparation for Use
System preparation (continued)
Caution:
 Be very careful to prevent the unit [1.90kg (4.19lbs.)] from
falling when mounting on the wall.
 Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The unit may fall.) If
unsure, consult a qualified service technician.
 Mounting screws are not supplied. Use appropriate ones.
 Check all wall mount angle screws for looseness.
 Select a good location. If not, accidents may occur or the unit
may get damaged.
 SHARP is not responsible for accidents resulting from
improper installation.
 Driving screws
SHARP designed the units so you may hang them on the wall.
Use proper screws (not supplied). See below for size and type.
 Wall mount angle fixed to the wall
(Horizontal position)
(Continued to the next page)
To mount the unit on the wall
3.2 mm (1/8")
9 mm (3/8")
Min. 22 mm (7/8")
5 mm
(3/16")
1 Fix the pattern paper to the wall in horizontal position
as below.
2 Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
3 Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
29 mm
29 mm
44 mm
44 mm
509 mm
Pattern paper
Wall surface
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")