Sharp HT-SB350(W)

E-19
HT-SB350(BK)
2010 August 16 HT-SB350_A6_EN_UK.fm
ENGLISH
HT-SB350(W)
References
Maintenance
 Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth.
Caution:
 Do not use chemicals for cleaning (petrol, paint thinner, etc.).
It may damage the cabinet finish.
 Do not apply oil to the inside of each component. It may
cause malfunctions.
Error indicators and warnings
When you fail to perform operations properly, the following
messages are displayed on the unit.
(*): Should the same message appear even if the unit is unplugged
and plugged in or is set to the stand-by mode and on again, contact
your local dealer where you purchased the unit.
Display Meaning
 Malfunction of the surround
circuit. Place the unit away from
noise source and plug the AC
power lead into another AC
outlet. (*)
or
or
 When there is no input signal.
Play back the connected
equipment.
 Nonstandard signal. Cannot be
recognized.
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
 Poor connection of the digital
audio input terminal.
Turn off the unit and check if the
cable is connected properly.
or
(Display blinks continuously)
Power indicator
(blinks red)
 When the protection circuit is
activated.