Sharp HT-SB350(W)

E-17
HT-SB350(BK)
2010 August 16 HT-SB350_A6_EN_UK.fm
ENGLISH
HT-SB350(W)
Basic Operation
General control (continued)
 Subwoofer level control
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
 Bass control
 Treble control
 Function
Note:
The backup function will protect the memorised function mode
for a few hours should there be a power failure or the AC power
lead becomes disconnected.
Auto power on function:
When you press the LINE / DIGITAL 1 / DIGITAL 2 button on the
remote control, the unit will turn on at the selected function.
Auto power off and auto detect signal:
 The unit will automatically go to stand-by mode (indicator
turns red) if :
1. No signal is detected within 20 minutes.
2. “d1” or “d2” display is blinking for 30 seconds during power
on.
 The unit will automatically power ON if it detects audio signal
from connected equipment, unless it is turned off manually.
The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL button.
To decrease the level, press the
SUBWOOFER LEVEL button.
1. Press the BASS/TREBLE button
to select “BASS”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
1. Press the BASS/TREBLE button
to select “TREBLE”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
-5 -4 ... 4 5
-5 +5
-5 +5
On the unit:
When the FUNCTION button is
pressed, the input source will change.
Press it repeatedly to select desired
input source.
On remote control:
Press the LINE button repeatedly to
select “L1” (LINE IN 1 input) or “L2”
(LINE IN 2 input).
Press the DIGITAL 1 button to select
"d1" or DIGITAL2 button to select "d2".
LINE IN 1
LINE IN 2
DIGITAL 1
DIGITAL 2