E-12
SPECIFICATIONS
How to replace the Plasmacluster Ion Generating Unit
1
2
3
Remove the claw
Insert to the claw.
Take the unit holder. (see E-10)
Remove the claw of unit holder and remove
the Plasmacluster Ion Generating Unit
Please do not dispose of the unit holder.
1 Attach a new Plasmacluster Ion
Generating Unit to the unit holder
2 Reattach the unit holder to the main unit
3 Reattach the main unit cover and fi lter
cover
Insert the car adapter in the accessory socket and check the unit replace
ment
light is turned OFF.
• After replacement, you may hear the sound “Zi, Zi ...”(sound
generated by Plasmacluster Ion) become louder, however, it is simply
because the Plasmacluster Ion Generating Unit has been replaced
with a new one. It is not a failure.
Note
Model IG-GC2Y
Power Car Adapter
Rated input DC12V
Rated output DC5V(Max.2A for 2 ports)
Operation mode LOW MED TURBO
Power consumption 0.5W 0.6W 1.9W
Ion density
Approx. 7,000
ions/cm
3
Approx. 25,000
ions/cm
3
Approx. 75,000
ions/cm
3
Operating noise level 19dB 23dB 36dB
Outer dimensions
Upper dimension: 74mm / Lower dimension 65mm /
Height: 162mm
(Excluding accessories)
Weight Approx. 260g (Excluding accessories)
Capacity applicable for high-density
Plasmacluster 25000
Approx.3.6m
3
Ú It is the index of capacity that approximately 25,000 ions blown out to the air
can be measured at the point near the center of the space (0.5m height from
fl oor) when the air volume is "MED" by placing the unit in an appropriate place
such as a cup holder beside the driver's seat.
IG-GC2.indd 12IG-GC2.indd 12 6/1/2559 BE 2:44 PM6/1/2559 BE 2:44 PM
To Next Page
Loading...