E-6
1
Insert the car adapter into the accessory socket and connect the USB
plug to the car adapter.
Note
• Be sure to remove any dirt from the
accessory socket. Failure to do so
could cause faultily contact or fi re.
• The car adapter has 2 USB ports, one of which the Plasmacluster Ion
Generator (IG-GC2) uses and another to connect equipment of 1.5A
or lower.
• The car adaptor (accessory) is for the ion generator “IG-GC2”.
It is possible to connect another equipment of 1.5A or lower while the
Plasmacluster Ion Generator is connected. However, in this case, the
normal operation of the additional equipment is not guaranteed.
• The car adaptor and/or connecting section could be hot while in use
and/or right after use.
Car Adapter
Accessory
Socket
USB Plug
2
Adjust the angle of louver
and put the unit in the cup
holder.
Approx. 55°
Approx. 20°
INSTALLATION GUIDANCE
Connecting the car adapter and installing the unit
IG-GC2.indd 6IG-GC2.indd 6 6/1/2559 BE 2:44 PM6/1/2559 BE 2:44 PM
To Next Page
Loading...