Installing the conditioner in the place mentioned above may cause the malfunction of the
system caused by water or high temperature inside the solar power conditioner.
III. Checking accumulated power
A. Check whether the solar power conditioner is in either of the following conditions.
The solar power conditioner is powered on (Indicator is displayed on the solar power
conditioner display).
The solar power conditioner is not powered, but connected to the utility.
B. Press SELECT button. The display panel displays the accumulated daily power with
displaying “Wh/D”.
C. Press SELECT button again. The display panel displays the accumulated total power with
displaying “kWh”.
No pressing any button for 10 seconds returns to output power displaying.
Press SELECT button to turn on the backlight during the night.
SELECT button
11
To Next Page
Loading...
