7
Required tools or items
Besides the supplied items on the previous page, the following tools or items are necessary.
Tools:
• Measuring tape (longer than 1 m)
• Screw drivers Phillips and Flat-head
• Electric driver Torque: 0.78~3.4 N.m
• Nipper
• Hammer
• Pliers
• Wire strippers
• Utility knife
• Socket wrench and fittings
• Torque wrench
• Open-end wrench
• Electric drill
• Drill bits ∅6mm, 7mm, 8.5mm
• Cord reel
• Ladder (if necessary)
• Stepladder
• Low-voltage gloves
• Helmet
• Waste cloth
• Pencil or pen
• Cable tie
• Insulating tape
• Sealing putty
• Multimeter Max usable DC voltage: more than 400V
• Frequency counter
• Ground tester
• Level
• Calculator
Items:
• Grounding wire (AWG 10)
• Wiring cable (refer to page 13)
• Conduit pipe (3/4”)
• Conduit hubs (For 3/4” holes, Liquidtight and wet-location hubs that comply with
the requirements of UL 514B)
• AC disconnect
• DC disconnect
To Next Page
Loading...
