20
6. Insert the cable into the slot.
Slot
SETTING
INV
SVC
ENTRY SELECT
7. Insert the smaller 4-pin connector of the cable to the connector in the display.
(listen for clicking sound that ensures it is locked in place).
Installing Display in a Socket Box
If you want to install the display on a wall, refer to
Installing Display onto a Wall
.
1. Insert the cable into the groove on the backside of the display.
Groove
2. Position the display and tighten by included screws. If installed in the dual outlets, use A opening
for screws, and if in the four outlets, use B. Do not expose the cable to abrasion risk.
Socket Box
B
A
B
A
When the procedure is completed, hook the top of the front cover on the hook of the display, and push the bottom side of the
cover until you hear a clicking sound.
To Next Page
Loading...
