Advantech WebAccess Device Driver Guide Sharp JW 10 Serial
Version 6.0 rev 0 Advantech Corp., Ltd. page 6
Comport.
7. Configure Baud Rate, Data Bit, Stop Bits and Parity to match those in
the PLC. All PLCs on this Comport must use the same settings.
The default settings (memory #236 or #226 = 00000000) are:
Data Length = 7 bits
Stop Bits = 1
Parity = None
Transfer Rate = 19200
PLC Address = 01
8. Configure a SharpJW Device (determines the communications
Protocol or Device Driver) using Add Device
9. Use Add Tag to create tags.
10. Select a Parameter to match the type of data to be read (Analog
Input, Analog Output, Digital Input, Digital Output). The Address of
the data must match the Parameter Type:
11. Modify the Address to match the actual address.
12. Apply a Tag name.
13. Edit Tag to assign Alarms, Scaling, Engineering Units, Description and
other features.
3.2 Serial Comport Properties
The Serial Comport is associated with an RS232C or RS422A port on the
SCADA Node PC (usually an RS232C port). This number must match the
actual COM1, COM2, etc on the SCADA node.
To Next Page
Loading...