E2 : Induction coil is too high, switch
the hob o by pressing on/o button
and let the coil cool down
E3 : Supply voltage is other than the
rated values. Switch the hob o by
pressing on/o button,wait until “H”
disappears for all zones, switch the
hob on by pressing on/o button and
continue to use. If the same error is
displayed again, call an authorised
service agent.
E4 : Supply frequency is dierent from
the rated values. Switch the hob o
by pressing , wait until “H” disappears
from all zones, switch the hob on by
pressing and continue to use. If the
same error is displayed again, switch
the plug for the appliance o and on.
Switch the hob on by pressing and
continue to use. If the same error is
displayed again, call an authorised
service agent.
E5: Internal temperature of the hob is
too high, switch the hob o by pressing
on/o button and let the heaters cool
down.
E6 : Communication error between
the touch control and heater. Call an
authorised service agent.
E7 : Coil temperature sensor is disab-
led. Call an authorized service agent.
E8: Cooler temperature sensor is
disabled. Call an authorized service
agent.
EA: Large Coil Saturation Error.
Switch the hob o by pressing on/o
button, switch the hob on by pressing
on/o button and continue to use. If the
same error is displayed again, call an
authorised service agent.
EC : Supply Voltage Error.Switch
the hob o by pressing on/o button,
switch the hob on by pressing on/o
button and continue to use. If the same
error is displayed again, call an autho-
rised service agent.
C1-C8:Mcroprocessor alert. Switch
the hob o by pressing on/o button,
switch the hob on by pressing on/o
button and continue to use. If the same
error is displayed again, call an autho-
rised service agent.
To Next Page
Loading...
