Sharp KP-19S - Page 10

10
REMOVE OF UPPER RING ASSEMBLY AND HANDLE
1. Detach the lid ass’y and remove the body in accordance with “REMOVE OF BODY”.
2. Remove the thermostat, mounting bracket and heater set assembly in accordance with “REMOVE OF
THERMOSTAT” and “REMOVE OF HEATER SET ASS’Y”.
3. Remove the glass pipe in accordance with “REMOVE OF GLASS PIPE” and remove the ball holder ass’y.
4. Remove the upper ring assembly by pulling it downwards.
5. Remove the handle.
Note 1 : When setting the handle, position it correctly. If reversely set, the handle will come off while using.
Note 2 : For alignment of the inner pot and upper ring, have the corner of hitch part of the upper ring engaged
with welded mark of the inner pot.
Welded mark
of the upper ring
Fig. 13
Fig. 14
Handle
Upper ring
Upper ring
Ball holder ass’y
REMOVE OF HEATER SET ASS’Y
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Remove the nut at terminal ass’y to release lead wire from the heater set ass’y.
3. Detach the mounting bracket by remove 2 screws holding the mounting bracket.
4. Disconnect the connector lower from the pipe of inner pot.
5. Unfasten 2 screws at heater set ass’y and then pull
heater set ass’y out from inner pot.
6. Now heater set ass’y is free.
Fig. 11
Fig. 12
Approx. 7-8 mm.
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect 2 terminals from the thermostat.
3. Remove 2 screws holding the thermostat.
4. Now the thermostat is free.
REMOVE OF THERMOSTAT
Inner pot
Screw
Thermostat
Inner pot
Heater set ass’y
Screw
Heater holder-A