9
REMOVE OF BODY
REMOVE OF TEMPERATURE FUSE ASS’Y
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect 3 lead wire of temp. fuse ass’y .
3. Disconnect the 2 terminal of thermostat.
4. Now temp. fuse ass’y is free.
1. Remove the bottom cover in accordance with “REMOVE OF BOTTOM COVER”.
2. Remove the screw holding earth wire to body.
3. Pull out the body and delivery base cover by toward its bottom.
4. Detach the body from the delivery base cover.
5. Now body is free.
Fig. 9
Fig. 10
Insert by
approx. 10 mm.
Connector
lower
Screen
Glass pipe
Connector upper
The screen must be faced to arrow mark when glass pipe is inserted to connector lower.
Glass pipe
Connector lower
Screen
REMOVE OF GLASS PIPE
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect the connector lower from the pipe of inner pot.
3. Disconnect the glass pipe from the connect upper.
4. Remove the connector lower from the glass pipe.
5. Now the glass pipe is free.
Note : Re-install glass pipe in accordance with Fig. 9.
Temp. fuse lead wire yellow
Terminal
Thermostat
Temp. fuse ass’y
Thermostat lead wire blue
To Next Page
Loading...
