Sharp KS-R23ST - REMOVE OF HEATER PLATE ASSEMBLY; REMOVE OF BODY

7
Heater plate
1. Remove the bottom cover in accordance with “REMOVE OF BOTTOM COVER”.
2. Remove 2 screws holding the lead wires
to the heater plate ass’y.
3. Remove 3 screws holding the heater
plate ass’y to the outer pot.
4. Now the heater plate ass’y is free.
REMOVE OF HEATER PLATE ASSEMBLY
1. Remove the bottom cover in accordance with “REMOVE OF BOTTOM COVER”.
2. Disconnect the lead wires of the panel.
3. Remove the nut and 2 screws holding to the body.
4. Insert the flat type screwdriver into the gap between the upper ring and latch hook cover, to pry the latch hook
cover from the upper ring.
5. Detach the dew receiver from the upper ring.
6. Insert the flat type screwdriver or similar to pry the claw of the hinge cover and remove it.
7. Separate the body from the upper ring by rubber hammer knock the upper ring. Fig. 6
8. Remove the panel in accordance with “REMOVE OF PANEL”.
9. Now the body is free.
REMOVE OF BODY
Fig. 6
Latch hook cover
Body
Upper ring
Flat type screwdriver
Hinge cover
Dew receiver
Screw
Panel
Screw
Nut
Screw
Outer pot
Screw
Fig. 5
Lacth hook cover
Body
To knock