Sharp KS-R23ST - REMOVE OF TEMP. FUSE ASSEMBLY; REMOVE OF THERMOSTAT (CUT OFF); REMOVE OF LID ASSEMBLY

9
Fig. 10
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect the lead wires from heater plate ass’y and remove the screw holding temp. fuse angle.
3. Remove the temp. fuse ass’y from the temp. fuse angle. (Fig. 9)
4. Now the temp. fuse ass’y is free.
Note : When reassembly take care so that the charged part of temperature fuse assembly does not protrude
from the TUBE-TA and securely fix it to the temperature fuse angle and then fix it with a screw to the
outer pot.
REMOVE OF TEMP. FUSE ASSEMBLY
1. Remove the body in accordance with “REMOVE OF BODY”.
2. Disconnect 2 lead wires to the thermostat (cut off).
3. Remove 2 screws and detach the thermostat (cut off) from the outer pot.
4. Now the thermostat (cut off) is free.
REMOVE OF THERMOSTAT (CUT OFF)
1. Detach the dew receiver from the upper ring.
2. Insert a flat thin screwdriver or similar into the gap between upper ring hinge cover remove the hing cover.
3. Remove the clossed therminal (3 pcs.) and disconnect lead wires from the outer pot.
4. Fixing the shaft sus by using plier, remove the shaft sus from the lid ass’y.
5. Now the lid ass’y is free.
REMOVE OF LID ASSEMBLY
Outer pot
Inner pot thermo angle
Thermostat (Cut off)
Temp. fuse ass’y
Temp. fuse angle
Screw
Fig. 9
Plier
Lid ass’y
Shaft sus
Upper ring