Pin No Terminal Name I/O Description
Pin No Terminal Name I/O Description
1 OPC OPC input
2 CCKM Cable connection detection
3 AVCC 5 V input
4 X_OUT Sub clock terminal
5 X_IN Sub clock terminal
6 VCL Not used
7 RES Reset input
8 TEST Not used
9 VSS GND
10 OSC2 System clock terminal
11 OSC1 System clock terminal
12 VCC 5 V input
13 TMDS_VSH_IN Power supply detection
14 CSEN1 Power failure detection
15 SMPOW Power supply control output
16 PANELPOW Panel power supply control
17 FREERUN Freerun switching
18 L_FL_ERR Lamp error detection
19 POWDTC_M Power failure detection
20 DDC_POW Cable connection detection
21 QS_DLL_CHK QS operation detection
22 OPT2 Not used
23 OPT1 Not used
24 FAN_ERR Fan error detection
25 W_PROT_M Write control output
26 CONFIG_SDA I2C_SDA
27 CONFIG_SCL I2C_SCL
28 TMDS_RST Reset output
29 MSTATE Startup detection
30 LSYNC No signal detection
31 DDC_SDA Control bus line data
32 TV_POW Power supply control 1
33 TV_POW2 Power supply control 2
34 REQ Transmission control
35 F_MODE1 Write control input
36 VSH_OUT Power control
37 DACCS1 DAC control CS output 1
38 DACCS2 DAC control CS output 2
39 PMUTE Image mute control output
40 DDCRST Reset output
41 F_MODE2 Pull-up to H
42 MOTOR+ Not used
43 MOTOR- Not used
44 PHOTO Not used
45 RXD0_M Asynchronous receive input
46 TXD0_M Asynchronous send output
47 DDC_SCL Control bus line CLK
48 MP_CLK Three-wire serial bus clock
49 MP_CS Three-wire serial bus chip select
50 MP_DA Three-wire serial bus data
51 IREM Remote control signal input
52 CSEN2 Startup detection input
53 SR_UP Power supply detection
54 STBY_POW Power standby key input
55 POWG_LED Power supply LED (green) control
56 POWR_LED Power supply LED (red) control
57 HDCP_SDA IIC SDA
58 HDCP_SCL IIC SCL
59 AREA1 Model setting input
60 KEY2 Key input 2
61 KEY1 Key input 1
62 OSTEMP Temperature detection input
63 AREA2 Model setting input
64 MOTOR_CHK Not used
To Next Page
Loading...
