12
LC-32LD164
LC-32LD165
LC-32LD166
Operation Manual (Continued)
LC-50LD264–LC-50LD265–LC-50LD265RU–LC-50LD266
9
Wall Mounting
TV screen size (Inches)
VESA-compatible wall bracket
(millimeters) (W x H)
Screw type(Metric)
mm 81 x 6M mm 004 x 004 "05
Preparation
Installing Batteries in the Remote Control Unit
1 Remove the battery compartment from the remote control.
2 Insert two “ AAA” size batteries (supplied with the product).
• Place the batteries with their terminals corresponding to the (+) and (-) indications in the battery compartment.
Caution
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.
• Do not mix batteries of different types. Different types of batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical
leakage of old batteries.
• Remove batteries as soon as they are worn out. Chemicals that leak from batteries come in contact with skin can cause
a rash. If you find any chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
• If you will not be using the remote control unit for an extended period of time, remove batteries from it.
• The batteries (batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
LC-50LD264–LC-50LD265–LC-50LD265RU–LC-50LD266
8
Preparation
Supplied Accessories
Note
• Always use the AC cord supplied with the TV.
• The illustrations above are for explanation purposes and may vary slightly from the actual accessories
Attaching/Detaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC IN terminal.
• Before attaching (or detaching) the stand, spread a cushion under the TV to prevent it from being damaged.
Caution
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Put the TV face down on a safe surface that is covered by a soft and smooth cloth.
2 Adjust the TV stand to the bottom of the TV.
3 Fasten the screws by using a cross-head screwdriver (Not supplied).
Caution
• To avoid damages, do not push too hard or put excessive pressure to the stand neck while turning the TV
to suit your comfortable viewing angle.
Note
• To detach the stand, perform the steps in reverse order.
To Next Page
Loading...
Need help?
General