Conncting a USB device or external devices
12
-
• Video playback via a USB device may not be possible
or the playback quality affected if the device data
transfer speed rating is too low�
• File number over 1000 may not be displayed�
• No quickly operation between play / pause /
fast forward / rewind�
• The video might get judder or unsmooth when USB
read/write speed is under requirement(some Full HD
format)�
• Files in USB 1�1 devices may not be played properly�
• Some video file formats may not be played depending
on the file�
Inserting the Smartcard into CA module
In order to receive coded digital stations, a Conditional
Access module (CA module) and a Smartcard must
be inserted into the CI (Common Interface) slot of the
TV�
The CA module and the Smartcard are not supplied
accessories� They are usually available from your
dealer�
Inserting the Smartcard into the CA module
1� Carefully insert the CA module into the CI slot
with the contact-side forward�
2� The logo on the CA module must be facing
outward from the rear of the TV�
NOTE
• It takes about 30 seconds to certify the license key
when you insert a Smartcard into the CI+ compatible
CA module for the first time� This process may fail
when there is no antenna input or you have never run
“Auto installation”�
• The CI+ compatible CA module sometimes upgrades
its firmware� You may not receive any TV images before
upgrading� You can only use the power button during
upgrading�
• The CI+ compatible CA module does not allow you to
output any copy protected programmes using monitor
out�
• If the TV displays an update confirmation message
for the Smartcard while receiving CI+ compatible
broadcasts, follow the screen prompts�
• Make sure that the CA module is properly inserted�
Checking CA module information
After inserting and activating the CA module, make
sure the input source is TV�
NOTE
• This menu is only available for digital stations�
• The content of this menu depends on the provider of the
CA module�
Module: General information on CA module displays�
Menu: Adjustment parameters of each Smartcard
displays�
Enquiry: You can input numerical values such as
passwords here�
HDMI connection
System Standby
• When set to “On”, turning off the TV will
automatically turn off the connected HDMI-CEC
compliant device �
Audio return channel (ARC)
The TV can send audio data for video content shown
on the TV to a connected audio device with just one
ARC-compatible HDMI cable� Using this function
eliminates the need to use a separate digital or
analogue audio cable�
Connection for using “Audio return channel”
• You need to use ARC-compatible cables/devices
and connect to the HDMI 1 terminal to activate this
function�
Supported display resolutions
Computer formats (PC)
Resolution Refresh rate
640 x 480 60Hz
800 x 600 60Hz
1024 x 768 60Hz
1280 x 768 60Hz
1360 x 768 60Hz
1280 x 1024 60Hz
Video formats
Resolution Refresh rate
480i 60Hz
480p 60Hz
576i 50Hz
576p 50Hz
720p 50Hz, 60Hz
1080i 50Hz, 60Hz
1080p (HDMI only) 50Hz, 60Hz, 24Hz
To Next Page
Loading...
Need help?
General