Sharp LC-32LD172E User Manual

-
5
Preparation and Watching TV
Using the remote control
Use the remote control unit by pointing it towards the
remote control sensor� Objects between the remote
control unit and sensor may block proper operation�
Remote control sensor
30º (5 m)
Horizontal
(7 m)
0º
• If you are not going to use the remote control for a long
time, remove the batteries to avoid damaging remote
control caused by chemical leakage�
Display the Menu Screen
Press MENU on the remote control to display the
menu screen�
Select an item by the remote control
Main Menu
RETURNEXIT
TV
Setup
Parental
Picture
Sound
Access
OK
Smart Picture
Backlight
Contrast
Brightness
Saturation
Sharpness
Tint
Colour Temperature
16:9 Overscan
Standard
90
50
50
10
0
Normal
Advanced Video
On
Select
Picture
1/2
32”
75 58 68
40” 50”
3
1� Press to select the desired menu�
2� Press to select / adjust the item to the desired
level� The new setting on the screen is applied
immediately�
3� Press EXIT to return to the previous layer�
Exit the Menu Screen
Press EXIT or Menu to exit the menu screen�
Run the auto installation
Follow the onscreen instructions to select your
preferred Language, Country, Scan Mode, Auto
tuning, and Location�
• Antenna installation
Select the Antenna option from the Auto tuning
screen, and press OK to start Auto CH Search�
• Cable installation
Select the Cable option from the Auto tuning screen�
Then, select the Operator when the selection is
available (depending on the country)� You can also
select Network ID from this screen� Enter the Network
ID manually by using the number buttons�
• Prefer Satellite installation
Select Pay-TV channels form HD+, Sky, Digiturk and
OTS�
• General Satellite installation
To select Antenna System settings (One LNB/
MiniDiSEqC/ DiSEqC 1�0/ Single Cable) or you can
press OK to skip the setting�
Daily operation
Turning on/off the power
Turn on the power by pressing the button on the TV�
Turn off the power by pressing again the button on
the TV�
Changing channels
Change channels by pressing P button�
Standby mode
E
To standby mode
If the TV set is switched on, you can switch it to
standby mode by pressing B button on the remote
control�
E
Switching on from standby
To switch on from standby mode, press B button on
the remote control�
TV indicator status
B indicator
Status
Off Power off
Red Standby
Blue Power on
NOTE
• If you are not going to use this TV for a long period of
time, be sure to remove the AC cord from the power
outlet�
• A small amount of electric power is still consumed even
when the power is turned off�

Sharp LC-32LD172E Specifications

General

Brand	Sharp
Model	LC-32LD172E
Category	LCD TV
Language	English