LC-32/40/46LE705E/S, LU705E/S, LX705E, LC-52LE705E/S
1 – 5
5. Removing of Bezel Ass’y, Panel Chassis Ass’y, Lens Sheet, Diffusion Plate, Back Light Chassis and LCD
Control Unit (46 inch models).
NOTE: A clean booth is required for repair of the component units and/ or parts (LCD Panel HIRAKI, LED PWB etc.) inside the LCD panel module
unit.
1. Remove the 10 lock screws ,16 lock screws and detach the Bezel Ass’y .
2. Remove the 4 Clips and detach the 46” LCD Panel HIRAKI Unit and Panel Chassis Ass’y .
3. Detach the DBEF Sheet and 2 Lens Sheet and Diffusion Plate .
4. Remove the 23 Push Rivets and 11 Support Pins and detach the Reflector Sheet .
5. Detach the 2 Connection Cords .
6. Remove the 48 Push Rivets .
7. Detach the Bush Cap Unit and connecting cords from the 8 connectors of the LED5-PWB1/2 Unit.
8. Remove the 8 Terminators and 16 connections and detach the 4 LED8-PWB1 Units , 4 LED8-PWB2 Units , 4 LED6-PWB1 Units
and 4 LED6-PWB2 Units .
9. Detach the 4 LED5-PWB1 Units and 4 LED5-PWB2 Units .
10.Detach the Back Light Chassis .
11.Detach the 2 Ferrite Cores .
12.Remove the 6 lock screws and detach the LCD Control Unit .
2
4
1
16
15
19
23
18
22
20
17
17
21
3 Bezel Ass'y
46" LCD Panel HIRAKI Unit
Clip
Panel Chassis Ass'y 5
DBEF Sheet 6
Lens Sheet 7
Diffusion Plate 8
Support Pin10
Push Rivet9
Reflector Sheet11
13
24 Back Light Chassis
27LCD Control Unit
12 Connecting Cord
25
26
Ferrite Core
14 Bush Cap Unit
To Next Page
Loading...
