32
LC-40LE732
LC-46LE732
7.Initialization to factory setting
8. SMART LOADER
Description.
The Smartloader is a function implemented in the service software of SEES designed L730 series intended to easily
replicate the user settings of one TV into another. These settings include (but not restricted to): picture and audio, tun-
ing set-up, language and country selection, PIN, child locked programs… Factory adjustments are not copied as they
are different for every TV.
The Smartloader makes possible the user data to be stored in a memory device connected to the USB terminal of the
TV that is used as reference and later load those data into other TVs by using their respective USB terminal.
How it works.
In reference TV:
1. Insert a memory device in the USB slot.
2. Enter in service mode, select Factory Menu and SMARTLOADER option.
3. Select “Save settings to USB” and press the RIGHT cursor in the remote control.
4. Wait until “OK” is displayed, the fi le has been successfully created in the root directory of the memory device.
In case of error, an explanation message is shown.
In TV to be cloned:
1. Insert a memory device with a fi le in it obtained following the above procedure.
2. Enter in service mode, select Factory Menu and SMARTLOADER option.
3. Select “Load settings from USB” and press the RIGHT button in the remote control.
4. After some seconds, “OK, reboot TV set” is displayed. In case of error, an explanation message is shown.
5. As indicated, reboot the TV to load the new settings.
Very important: All the TVs must have the same software version and hardware.
Caution: When the factory settings haves been made, all user setting data, including the channel settings, are initialized.
The adjustments done in the adjustment process mode are not initialized.) Keep this in mind when initializing these set-
tings.
1. Enter in Service Mode.
2. Press “▼” or “▲” key until selecting INIT.
3. Press OK key.
4. INIT menu appears and “Factory init” option is selected.
5. Press “►” and select the option desired (EURO/RUSSIA/NORDIC/UK/EAST EUROPE).
6. Press OK key and initialization starts.
7. WEST EURO OK message appears for EURO option when the setting is complete.
RUSSIA OK message appears for EURO option when the setting is complete.
NORDIC OK message appears for RUSSIA option when the setting is complete.
UK OK message appears for UK option when the setting is complete.
EAST EUROPE OK message appears when the setting is complete.
Note: Never turn the power off during initialization.
TV restarts in “Initial Installation” menu. The following settings will be back to their factory ones:
• User settings
• Channel data (e.g. Broadcast frequencies)
• Maker option setting
• Password data.
To Next Page
Loading...
Need help?
General