35
LC-40LE732
LC-46LE732
SOFTWARE UPGRADING
1. Main Unit Software Upgrading (USB)
1.1. Introduction
1.1.1. In order to proceed with the Software Updating do not enter into Service Mode.
1.2. Procedure
1.2.1. Insert the USB memory into a side USB terminal with the fi le name “zTVApp_Complete.zimage” on
the root directory.
1.2.2. Once detected the USB it will appear on screen the following request:
1.2. 3. Press “◄” until selecting “Yes”.
1.2. 4. Press “OK”.
• The software update process starts.
• “Software upgrading progress **%” message appears.
NOTE: During the upgrading process, do not power-off the TV set.
• Once fi nished the process the following success or failed message appears .
1.2. 5. Remove the USB Drive.
1.2. 6. Press OK to reset the TV.
1.2.7. In case of failure, please repeat the upgrade process again.
To Next Page
Loading...
Need help?
General