Sharp LC-50LB261U

54
LC-50LB261U Sharp 50" LED TV
www.sharpusa.com
Playing TV audio only
You can turn off the picture on your TV and listen to
the program audio only.
1 Press MENU. The on-screen menu opens.
2 Press
W or X to highlight CHANNELS, then press T
or ENTER. The CHANNELS menu opens.
3 Press
S or T to highlight Audio Only, then press
ENTER.
4 Press
S or T to select On.
5 Press MENU to return to the previous menu, or
press EXIT to close the menu.
Changing channel
settings
Automatically scanning for channels
When you scan for channels, your TV searches for
channels with signals and stores the channel
information in the channel list. When you press CH
or CH , your TV goes to the next or previous
channel in the channel list.
If the TV signal source changes, for example you
change from an outdoor antenna to cable TV (no
box), you need to scan for channels.
1 Press MENU. The on-screen menu opens.
2 Press
W or X to highlight CHANNELS, then press T
or ENTER. The CHANNELS menu opens.
3 Press
S or T to highlight Auto Channel Search,
then press ENTER. The CHANNELS · AUTO CHANNEL
SEARCH screen opens.
4 Press
S or T to highlight Antenna, Cable, or
Satellite Box, then press ENTER.
A If you select Antenna, your TV scans for
available channels. The scan may take several
minutes.
Notes
• The picture turns off in about five
seconds.
• Audio Only works only when the
input source is TV and your TV is
receiving a broadcast signal.
• To exit audio only mode, press any
button. When you exit audio only
mode, the Audio Only option is
automatically reset to Off.
Note
You can press EXIT to stop the auto
channel search, but you will need to run
the auto channel search again to create a
channel list.