On-Screen Display Menu
Example
Example
®
®
®
The bar above is an operational guide for
the remote control. The icon of the button |
operated by the remote control will turn white. J
1 Press MENU to display the MENU screen.
2 (t_ Press _/_. to select the desired menu.
(25 Press A/Y to select a specific adjustment item.
:_3_Press 4/1_ (or ,_,/_') to select or adjust the
desired setting, and then press ENTER.
3 Press MENU to exit.
Item displayed in light blue
• This indicates the item currently selected.
® This indicates the current setting for the item.
® Item displayed in white
• This indicates that the item can be selected.
Item displayed in gray
o This indicates that the item cannot be selected.
There are various reasons why the items cannot be
selected, but the main reasons are as follows:
--Nothing is connected to the selected input terminal.
--The function is not compatible with the current input
signal.
o Menu options differ inthe selected input modes, but the
operating procedures are the same.
o The screens in the operation manual are for explanation
purposes (some are enlarged, others cropped) and may
vary slightly from the actual screens.
o The order of explanations for each menu item in the
following pages is not necessarily in accordance with the
alignment of the items on the screen.
II iiii_:,
Using the remote control
Use the following buttons on the remote control to
operate the menu.
Using the control panel of the main unit
You can also operate the menu with the control panel
of the main unit.
Button operations on the control panel correspond to
the ones on the remote control as shown below.
MENU: Press to open or close the menu screen.
A/T/41/D,-: Press to select a desired item on the screen or
adjust a selected item.
ENTER: Press to confirm the settings of Reset.
RETURN: Press to return to the previous step.
_ i _ MENU: MENU on the
rer_ote control.
INPUT: ENTER on the
remote control
CHA/V: Cursor A/T
on the remote
control.
VOL + I- :Cursor _II_
on the remote
control.
18
To Next Page
Loading...
