27
DisableEnable
Press MENU to exit.
5
Power Control
Power control setting allows you to save energy.
NOTE
• “Disable” is the factory preset value.
• When a TV program fi nishes, this function may not operate.
NOTE
• “Disable” is the factory preset value.
Press MENU and the MENU screen displays.
Press
c
/
d
to select “Power Control”.
Press
a
/
b
to select “No Signal Off”, and
then press ENTER.
Press
c
/
d
to select “Enable”, and then
press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Repeat steps 1 and 2 in No signal off.
Press
a
/
b
to select “No Operation Off”, and
then press ENTER.
Press
c
/
d
to select “Enable”, and then
press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Basic adjustment settings
1
2
4
3
1
2
3
Press MENU to exit.
4
No signal off
When set to “Enable”, the power will automatically shut
down if there is no signal for 15 minutes.
32D41U_en_e.indd 2732D41U_en_e.indd 27 2006/05/17 11:52:372006/05/17 11:52:37
To Next Page
Loading...
Need help?
General