: Continuous record menu
PLAY
T R E C
Continuous Rrecord
A P # # # #
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set.
* In the start address set state the start address changes as follows when the [DISP] key is pressed.
• Continuous record from the current pickup position
: Continuous record menu
: Start address setting
: Continuous record
# # # #: Address
: Continuous record
# # # #: Address
PLAY
T R E C
A d 0 0 5 0
PLAY
A P # # # #
• Continuous record playback from any address
A d 0 0 5 0
0 0 5 0
H
(initial value) 0 3 C 0
H
0 7 0 0
H
0 8 A 0
H
A d 0 3 c 0
DISP
A d 0 7 0 0
DISP DISP
DISP
A d 0 8 A 0
* In the start address setting state the start address change digit changes when the [BASS] key is pressed.
* In the start address set state the value of selection digit changes in the range of 0h to Fh wh
en the [SKIP UP/DOWN] key is pressed.
* In the continuous record state and start address set state the record laser power changes in t
he range of "0h to Fh" when the [VOL UP/DOWN] key is pressed.
A d 0 0 5 0
1st digit (initial value) 2nd digit 3rd digit
A d 0 0 5 0
BASS
A d 0 0 5 0
BASS
BASS
: INNER switch position measurement menu
: Continuous playback (pit section)
# # # # : Address
PLAY
I N N E R
Inner Switch Position Measurement
S Q # # # #
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set.
: TEST mode normal playback menu
: Continuous playback
@@@@@: Mode and address display
PLAY
N O R M A L
Test Mode Normal Playback
@ @ @ @ @
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set.
: Digital input single monitor menu
: FS code, C bit data display
: Address
: Control code
: Category code
PLAY
D i n M o n
Digital Input Signal Monitor
C
: U bit 1 data display
: TNO
: INDEX
SKIP UP
U 1
SKIP UP
SKIP DOWN
SKIP DOWN
: U bit 2 data display
: TIME (min.)
: TIME (sec.)
U 2
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set.
To Next Page
Loading...
