Sharp MD-MS701W - Page 26

MD-MS701W/MS702
– 26 –
: Focus setting menu
: Focus system loop filter gain constant setting  : setting : Focus system loop filter f-characteristics constant 1 setting  : setting Focus system loop filter f-characteristics constant 2 setting  : setting : FZC detection hysteresis level setting  : setting : FOK generation comparison level setting (normal)  : setting
: DISC-ID judgment high-reflection lower-limit level  : setting
: Focus-related other settings  : setting : FOK generation LPF factor setting (when focus "ON")  : setting : Focus servo amptitude  : setting : Auto-focus retraction waiting time setting  : setting : Focus search inclination  : setting
PLAY
F o c u s
Focus Setting
F G
F F 1
SKIP UP SKIP DOWN
F F 2
SKIP UP SKIP DOWN
F Z H
SKIP UP SKIP DOWN
F L n
SKIP UP SKIP DOWN
D J G
SKIP UP SKIP DOWN
F R V
SKIP UP SKIP DOWN
F P f
SKIP UP SKIP DOWN
F L V
SKIP UP SKIP DOWN
W T f
SKIP UP SKIP DOWN
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set. * In the specific state pressing the [DISP] key causes change to "focus setting menu". * In specific state the setting changed in the range of "00h to FFh" when the [VOL UP/DOWN" key is pressed. (The upper limit varies depending on the items)
F F S
SKIP UP SKIP DOWN
: Spin setting menu
: Spin system loop filter gain constant setting (until servo is turned on)  : setting : Spin system loop filter again constant setting (after servo is turned on, internal periphery)  : setting : Spin system loop filter gain constant setting (after servo is turned on, center)  : setting : Spin system loop filter gain constant setting (after servo is turned on, externalperiphery)  : setting : Spin system loop filter f-chracteristics constant 1 setting  : setting
Spin system loop filter f-chracteristics constant 2 setting  : setting
Spin system loop filter f-chracteristics constant 3 setting  : setting Spin system loop filter f-chracteristics constant 4setting  : setting Spin system loop filter f-chracteristics constant 5 setting  : setting : Spin drive PWM duty limiter setting  : setting : Spin-related other settings  : setting
PLAY
S p i n
Spin Setting
S P G
S P i
SKIP UP SKIP DOWN
S P m
SKIP UP SKIP DOWN
S P o
SKIP UP SKIP DOWN
S P 1
SKIP UP SKIP DOWN
S P 2
SKIP UP SKIP DOWN
S P 3
SKIP UP SKIP DOWN
S P 4
SKIP UP SKIP DOWN
S P 5
SKIP UP SKIP DOWN
S P D
SKIP UP SKIP DOWN
* When the "STOP" button is pressed in specific menu, the TEST MODE STOP state is set. * In the specific state pressing the [DISP] key causes change to "focus setting menu". * In specific state the setting changed in the range of "00h to FFh" when the [VOL UP/DOWN" key is pressed. (The upper limit varies depending on the items)
S P R
SKIP UP SKIP DOWN