Sharp MD-MT190H - Page 38

01/10/29 MD-MT190H(SEEG)_5.fm
E-31
MD-MT190H
ENGLISH
Advanced Features
-Titling a MiniDisc-
Titling a MiniDisc (continued)

To add characters

To erase a character
Press the VOL+ or VOL- button to move the cursor to the
character you want to erase, and then press the BASS
button.

To enter a space
Press the VOL+ button to move the cursor to the right.
Note:
One disc name and up to 255 track names can be cre-
ated per disc (a maximum of 100 characters for the disc
and each track name and a total of 1,700 characters can
be entered. However, if any tracks are recorded in the 2
times or 4 times long recording mode, the number of
characters to be entered is decreased, since the informa-
tion of the recording mode is stored by the track).

Characters (symbols)
1
Put the unit in the character input mode.
(Perform steps 1 - 4 on page 30.)
2
Press the VOL+ or VOL- button to move the cur-
sor to the character before which you want to add
a new character.
3
Select the character to add.
(Perform steps 5 - 7 on page 30.)
4
Press the MENU/CHRG button.

"TOC" will be displayed. To write the updated con-
tents to the MiniDisc, press the :OFF/HOLD but-
ton.

You cannot remove the MiniDisc whilst "TOC" is
displayed. "TOC" will not disappear until the re-
corded contents have been updated.
Space
A C D E F G H
B
1 3 4 5 6 7 8
2
a c d e f g h
b
I J K L M
S U V W X Y ZT
R
N
QP
.,
/
/.,
! " #
:
(
+
$
*
9 0
&
'
<; =
O
i j k l m
s u v w x y zt
rn o qp
.,
/
%
_
`
@
>
?
)
Capital letters
Lower-case letters
Numbers and symbols
indicates a space.