Sharp MD-MX30H User Manual

23
To store a station name again, if the wrong name
was stored in memory by mistake:
When you store station names in memory using the ASPM
function, the correct station names may not actually be stored
if there is lots of noise or if the RDS station signal is too weak.
In this case, try storing station names in memory using the
following procedure.
Notes:
● When there are no station names stored in memory, you
cannot use this function. In this case, when the STATION
button is pressed, "NOTHING" will flash for 5 seconds, and
the unit will return to the original display.
● This function can only be used when the FM band has
been selected.
● The same station name can be stored in different preset
channels. Therefore, when you are choosing a station name
from the presets, the same station name may be encoun-
tered more than once.
● In a certain area or during certain time periods, the station
names selected using the station select function may tem-
porarily be different from the name of the station you are
actually receiving.
(Continued)
1 Press the STATION button.
2 Within 6 seconds, turn the jog dial or press the PRE-
SET (
XX
XX
X or
WW
WW
W) button to check whether the station
names are correct.
3 If you find a station name that is wrong, press the STA-
TION button again within 6 seconds to recall the pre-
set station, which corresponds to the station name.
4 After the preset station has been received and the
correct station name has been displayed, press the
MEMORY/ENTER button.
5 Within 5 seconds, press the MEMORY/ENTER button
again whilst the preset channel number is flashing.
● The new station name has been stored in memory cor-
rectly.
2
4,5
2
1,3
1,3
4,5
*23-30 00.1.13, 11:59 AM23

Sharp MD-MX30H Specifications

General

Brand	Sharp
Model	MD-MX30H
Category	Speaker System
Language	English