Sharp MD-MX30H User Manual

40
■ Move
1 Whilst in the stop mode, select the track you want to
move using the jog dial.
Or start playing the track to be moved, and then press
the MD
0606
0606
06 button.
2 Press the NAME/TOC EDIT button, and within 10 sec-
onds, select "MOVE" using the jog dial.
3 Within 10 seconds, press the MEMORY/ENTER button.
4 Select the new track position using the jog dial.
● To cancel the operation, press the MD ■ button.
5 Press the MEMORY/ENTER button again.
● The track is moved, and the unit is stopped at the begin-
ning of the new track selected in step 4.
Notes:
● When a track has been moved, the other tracks which are
affected will be assigned new track numbers automatically.
● This function cannot be used in the random play mode and
APMS play mode.
(Continued)
To combine two non-contiguous tracks:
(Example: the first and third tracks)
Move the third track to the second track using the MOVE func-
tion.
Then, combine the first and second tracks using the COM-
BINE function.
Notes:
● Tracks recorded from analogue inputs cannot be combined
with tracks recorded from CDs or MiniDiscs using the dig-
ital inputs.
● Tracks recorded in the stereo mode cannot be combined
with tracks recorded in the monaural long-play mode.
● Tracks where either track's recording time is less than 15
seconds may not be combined.
● This function cannot be used in the random play mode and
APMS play mode.
A designated track can be moved to any desired
position.
● The numbers assigned to the tracks following the track
which is moved will be adjusted automatically.
CABD
12 34
12 34
ABCD
3,5
1
1,2,4
2
MD ■
*36-43 00.1.13, 0:04 PM40

Sharp MD-MX30H Specifications

General

Brand	Sharp
Model	MD-MX30H
Category	Speaker System
Language	English