2
21
5
/8"
21
7
/8"
14
19
/32"
9/64"
door thickness
23
7
/8"
15"
auto drawer
opening
1
3
/4"
4
11
/16"
4"
15
7
/8"
CLEARANCES ANd dImENSIoNS
Dimensions that are shown in Figure 1 must be used. Given
dimensions provide minimum clearance. Locate electrical
outlet in the shaded area in the upper left-hand corner of the
cutout. See Figure 7.
Contact surface must be solid and level. Pay special attention
to the oor on which the Microwave Drawer will sit. The
oor of the opening should be constructed of plywood strong
enough to support the weight of the oven (about 100 pounds).
Check location where the Microwave Drawer will be
installed for proper electrical supply.
Your oven can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
Be sur
e that the clearance of the oor between the wall oven
and the microwave drawer is a minimum of 2-inches.
24" mICRoWAvE dRAWER mEASUREmENtS
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric
or gas wall oven.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach. Power cord access hole in cabinet should be a minimum
1
1
/2" diameter hole and deburred of all sharp edges.
IMPORTANT
Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
To Next Page