31
CHANGING THE PORT
7
Click the [Next] button in the screen of
step 5.
8
Click the [Finish] button.
9
Click the [Close] button in the screen of
step 2.
When using a port created with "Standard TCP/IP Port"
When using a port created using "Standard TCP/IP Port", in the screen that appears after you click the [Configure Port]
button in the screen of step 3, make sure the [SNMP Status Enabled] checkbox is not selected ( ). If the [SNMP
Status Enabled] checkbox is selected ( ), it may not be possible to print correctly.
To Next Page
Loading...
