7-35
SYSTEM SETTINGS
Contents
*1 When a paper drawer is installed.
*2 When a finisher is installed.
*3 When a punch module is installed.
*4 When a colour-related problem has occurred.
Copy Function Settings
X Disabling of Offset Disabled 7-71
X Disabling of Stapler*
2
Disabled 7-71
X Disabling of Punch*
3
Disabled 7-71
X Disabling of Colour Mode*
4
Disabled 7-71
● Fusing Control Settings 60 - 89g/m
2
(16 - 23 lbs.) 7-71
Item Factory default setting Page
■ Copy Function Settings
7-72
● Initial Status Settings
7-72
X Colour Mode Full Colour
X Paper Tray Varies depending on the machine
configuration
X Exposure Type Auto
X Copy Ratio 100%
X 2-Sided Copy 1-Side to 1-Side
X Output –
● Other Settings 7-73
X Copy Exposure Adjustment
7-73 Colour 5
Black & White 5
X Rotation Copy Setting Enabled 7-73
X Add or Change Extra Preset Ratios – 7-73
X Setting a Maximum Number of Copies 999 7-73
X Initial Margin Shift Setting
7-73 Side 1 10 mm (1/2")
Side 2 10 mm (1/2")
X Erase Width Adjustment
7-73 Edge Clearance Width 10 mm (1/2")
Centre Clearance Width 10 mm (1/2")
X Card Shot Settings
7-73 Original Size X: 86 mm (3-3/8"), Y: 54 mm (2-1/8")
Fit to Page Disabled
X Initial Tab Copy Setting 10 mm (1/2") 7-73
Item Factory default setting Page
To Next Page
Loading...
