41
Copying a large number of originals at once (Job Build)
Using two machines to make a large number of
copies (Tandem Copy)
Using a different paper type for covers (Covers/Inserts)
Adding inserts when copying on transparency film
(Transparency Inserts)
A stack of originals higher than the
indicator line on the automatic
document feeder cannot be fed through
the feeder.
The job build function lets you divide
the stack of originals into sets, feed
each set, and copy the sets as a single
job.
You can divide a copy job between two
machines connected to the same
network.
This saves considerable time when
running a large copy job.
To use this function, the tandem
connection setting must be configured
in the system settings.
This function enables you to use a
different type of paper for the front and
back covers of a set of copies.
A different type of paper can also be
added as an insert at specified pages.
When copying onto transparency film,
this function inserts sheets of paper
between the sheets of transparency film
to keep them from sticking together.
4 sets
2 sets
2 sets
Back cover
Cover
Insert
Insert
Paper insert
Paper insert
Paper insert
To Next Page
Loading...
Need help?
General
