DATA SECURITY KIT (Cont’d)
When printing to a specific folder
without PIN, Error 421 occurs - only
when DSK is installed.
To print to a specific folder without PIN, perform the
following setting changes:-
1. Settings - Security Settings - Other Settings -
Disabling of Document Filing menu:- Un tick Sharing
Mode for Printer.
2. User Control - Authority Group List - Add Authority
group Registration - Job Setting - Security -
Document Filing Approval Setting menu:- Enable
Sharing Mode.
Is it possible to configure the MFP to
send only a single email alert for each
alert condition?
Upgrade the MFP firmware to February 2012 Running
Change (06.00.R1 or higher) and configure the
following soft switch:-
SIM 55-03 SW28-3 (change from 0 to 1).
Note: For dealer email address, multiple email
notifications will still be received.
Configuring Toner Low Email alerts to
be sent at a specific toner remaining
level
If you wish to receive toner low emails at a specific
toner remaining level, configure the MFP as follows:-
1. Enter Simulation 26-69.
2. Change Item F (Toner E-Mail Alert) from 1 to 0.
3. Set Item B (Remaining Toner Level) to the specified
level when the Email alert is sent:-
Examples: 0= 5%, 1=10%, 2=15%, 3=20%, 4 = 25%
(Default), 5=30%.
Note: Depending on Model, the details within
Simulation 26-69 may differ therefore please refer to
the Service Manual for the relevant model series.
To Next Page
Loading...
