Note: Excludes Part Change/Correction Information.
Enhancement of 1st transfer frame CL.
Measures to prevent PDPPD1_N paper jam caused by stray glue from DF
cushion.
Measures to prevent F1-31 trouble or FSDMJ paper jam in the saddle
section.
Printer installation under Mac OSX 10.10
Specification change to support the new wireless standard in Australia
Measures to prevent the noise from the DSPF drive unit and drive transport
frame.
Measures to prevent noise from the DV drive motor section on the main
drive unit.
Measures to prevent noise from the rear side of the pressure roller in the
fusing unit.
Measures to prevent E7-11 trouble caused by faulty LED driver PWB.
Further improvement to prevent fusing belt damage.
Elimination of ADU waste toner cover
Measures against toner smudge on the paper
Further improvement to prevent fusing belt damage.
Caution when installing IC Card Reader
Measures against PDPPD1_N paper jam caused by the deteriorated
cushion.
Setup of new service parts - Saddle stapler
Noise from the secondary transfer unit
Staple Unit & Staple Cartridge listing
Sharp Remote Device Manager [SRDM] v1.4
Measures to prevent F1-00 error code caused by the contact failure of the
paper surface detection sensor.
Rom version upgrade (includes revision history)
Elimination of two springs to improve productivity.
How to enable and configure the wireless function with MXEB13 USB
wireless adaptor.
Measures to prevent streaks in the paper path direction when printing solid
black and colour images.
Countermeasures against noise from the black toner transport pipe.
Registry growth when using an auto created printer under a Citrix or
terminal services environment.
Enhancement to prevent damage to the flag paper detect up (F1-15)
Elimination of the LCD protect molt of 10.1” operation panel for
productivity improvement.
Improvement for accurate detection of DSPF transport upper actuator to
prevent SPPD2_S paper jam.
To Next Page
Loading...
