Caution when replacing the fusing pressure spring.
Countermeasures against POD2_S and/or POD1_S paper jam when the
inner finisher is installed.
Measures to prevent HDD damage caused by vibration
Improvement for gap variation between the fusing separate plate and
fusing belt.
Enhancement of gear strength in the SD drive section
Improvement of paper alignment during the discharge
Elimination of the remain detect cover
Measures to prevent POD2_N jame due to deformed Fusing rear lower
paper guide sheet
Improvement for the height and clearance adjustment of MXFN10 during
installation
Support for MXEB13 USB Wireless Adaptor
Countermeasure against toner dispersion within the process unit
Measures to prevent the web idle gear from locking up
Sharp Remote Device Manager [SRDM] v1.3
Release of Pantone Look-up Table for Pantone licensed devices
Improvement against noise from the paper feed drive unit section
Enhancement to prevent paper jam caused by worn transport ribs on the
Cover Top
Improvement for C4-00 PTC trouble
Measures to prevent POD1_S jams due to paper touching the enter gate
when performing 2-side print with A3 paper.
Countermeasure for deviation of punch hole position
Enhancement to prevent paper jam caused by unhooked bunch roller
pressure lever
Improvement to prevent folding misalignment due to paper skew within
the saddle section
Countermeasures against paper jam in tray 3/4 caused by low voltage
output of the desk control PWB
Firmware update for installation of MXFN10 [revised February 2013]
Improvement to prevent toner leakage from the front side of primary
transfer cleaner unit
Enhancement to improve the life of WEB roller
Point to observe during routine maintenance - White streaks on print
output
Countermeasure to prevent paper jam due to undetected paper passing
the PPD2 sensor
Further improvement to prevent the fusing belt from meandering
Measures to strengthen the link fixing plates within the 1st transfer unit
Device cloning from the operation panel
Improvement for toner dispersion from the DV unit.
Change of main power LED indication
Measures to strengthen the attaching area of manual bypass feed drive
gear within the paper feed unit
To Next Page
Loading...
