Fusing pressure spring enhancement
Measures to prevent document jams (SPPD2_S) due to insufficient recovery
of the transport upper actuator.
F2-64/65/66/67 Trouble code
Defective contact with SD card terminal
Scan to OSX10.7 using FTP
Enhancement to prevent fusing belt damage
Fuser temperature adjustment for action against paper jam, due to curled
paper
Change of tilt angle steps for the operation panel
Improvement to prevent dirt on the rear edge of paper
Contamination of the fusing upper paper enter guide
Pressure release idle gear strength increase
Rom version upgrade (including revision history)
Rom version upgrade (including revision history)
Measures against paper skew when the saddle open and shut guide is not
fully closed
Countermeasure to reduce noise from the DSPF upper & lower transport
units
Improvement to the drum cleaning performance - Cleaning Blade
Stylus Pen & Holder established as a service part
Configuring ID card with internal user control
Enabling public folder & NAS (Network attached storage)
Home screen background customization
Noise reduction during initial operation
Sharp Remote Device Manager (SRDM) v1.1
Improved paper feeding performance
Precaution when replacing the fusing belt and web roller.
Additional protect sheet for MXEB12 mirroring kit
FPPD2_S jams within the saddle opening
F1-43 trouble when power is turned on
Rom version upgrade (to support MX-4111N/5111N)
IC Card reader installation guide
Rom version upgrade (including revision history)
Improvement of initial operation noise
F1-08 trouble due to an operation lock of the stapler unit
FPDD_S jams due to the spring of the UDG arm shaft breaking
Angled paper ejection due to the guide SR-SG-GP-F/R not opening correctly
Improved paper feeding performance through the saddle unit
To Next Page
Loading...
