Is it possible to configure the MFP to
send only a single email alert for each
alert condition?
To enable single email alert notification for Customer
Email address only, configure the following soft switch:-
SIM 55-03 SW28-3 (change from 0 to 1).
Note: For dealer email address, multiple email
notifications will still be received.
Configuring Toner Low Email alerts to
be sent at a specific toner remaining
level
If you wish to receive toner low emails at a specific
toner remaining level, configure the MFP as follows:-
1. Enter Simulation 26-69.
2. Change Item F (Toner E-Mail Alert) from 1 to 0.
3. Set Item B (Remaining Toner Level) to the specified
level when the Email alert is sent:-
Examples: 0= 5%, 1=10%, 2=15%, 3=20%, 4 = 25%
(Default), 5=30%.
Note: Depending on Model, the details within
Simulation 26-69 may differ therefore please refer to
the Service Manual for the relevant model series.
When switching from Internal User
Control to External Accounting Mode
(eg. Papercut), Unable to
Communicate with Authentication
Server error message occurs
Under User Control - Card Type / Card Reader Settings
menu, uncheck "Use IC Card for Authentication" and
power cycle the device.
Under External Account control (OSA),
is it possible to lower the Automatic
Log Out (User) timer from 60
seconds?
Under User Control - Default Settings menu, enable
Automatic Logout Setting and change to the required
time (eg. 30 seconds).
To Next Page
