Sharp MX-C507P - Page 111

5028
2 Open doors A and D, and then remove any paper fragments.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
3 Close doors D and A.
Paper jam in door A
Paper jam in the fuser
1
Open door A.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
2
Remove the jammed paper.
Note: Make sure that all paper fragments are removed.
Diagnostics and troubleshooting
77