Note:
An asterisk (*) next to a value indicates the factory default setting.
Print Configuration
Quiet Mode
Off*
On
Reduce the amount of noise that the printer makes when
printing.
Device Operations
Panel Menus
Off
On*
Set the printer to show the control panel menus.
Device Operations
Safe Mode
Off*
On
Set the printer to operate in a special mode, in which it attempts
to continue offering as much functionality as possible, despite
known issues.
Device Operations
Clear Custom Status
Erase all custom messages.
Device Operations
Automatically Display Error Screens
Off
On*
Show existing error messages on the display when the printer
returns to an active state.
Device Operations
Clean sensing and laser optics
Set the printer to run its wipers and clean the sensing and laser
optics.
Note:
This setting is available only in some printer models.
Device Operations
Calibration frequency preference
Disabled*
Fewest color adjustments
Fewer color adjustments
Normal
Better color accuracy
Best color accuracy
Set the printer to put down the correct amount of toner to
maintain color consistency.
Device Operations
Automatic Media Type Detection
Off
On*
Set the printer to detect the paper type being loaded.
Device Operations
Custom Supply Levels
Off*
On
Toner patch sensor setup
Calibration frequency preference
Set the printer to put down the correct amount of toner to
maintain color consistency.
Toner patch sensor setup
Full calibration
Run the full color calibration.
To Next Page
Loading...
