Printhead removal
Note:
Some printers might not have a printhead stop installed on the front left corner of the printhead. Make
sure that the stop is installed before removing the printhead.
Remove the top cover. See
“Top cover removal” on page 305
.
Check the front left corner of the printhead if a printhead stop is installed. If the stop installed, then proceed
to step 5. If the stop is not installed, then proceed to the next step.
Unpack the printhead stop and screw.
Place the stop (A) next to the printhead, and then fasten the stop with the screw (B).
To Next Page
Loading...
