MX-M1204 MX-M904/M1054/M1204 (MAIN UNIT) 2 – 10
(1) Turn ON the power of the main unit
1) Connect the power plug of the machine to the power outlet,
and turn ON the main power switch and the operation panel
power switch.
(2) Keyboard input check
1) Touch [E-Mail] on the touch panel.
2) Touch the input column of the address.
3) Input the address with the keyboard, and check the input result
on the touch panel.
(3) USB operation check
1) Insert the USB memory into the USB connector of the opera-
tion panel.
2) Check to confirm that the recognition mark of the USB memory
is displayed on the operation panel.
E. Fusing heat roller pressure
1) Open the front cover (a), and pull out the intermediate frame
(b).
2) Remove the screw (a), and remove the cover (b).
3) Insert a screwdriver into the pressure release shaft (a) to apply
pressure.
* When the pressure is released, the arrow on the pressure
release shaft faces diagonally (b). When the pressure is
applied, the arrow faces upward (c).
NOTE: If the machine is left unused for one month or more, the
heat roller rubber may be deformed. In such a case,
release the pressure.
F. Developer supply
1) Open the front cover (a), and pull out the intermediate frame
(b).
2) Remove the screw (a), and remove the cover (b).
3) Remove the blue screw, and remove the plate (b).
4) Slide the developing unit (a) to the right, and pull it out until the
grip (b) can be held.
a
b
a
b
a
c
b
a
b
a
a
b
To Next Page
Loading...
Need help?
General
